Research and Analysis of Automated Special Machine for Fastening of U-Frame and Screw
Vincent Balu

Vincent Balu, Department of Mechanical Engineering, Sanskriti University, (Uttar Pradesh), India.

Manuscript received on 05 October 2019 | Revised Manuscript received on 19 October 2019 | Manuscript Published on 26 December 2019 | PP: 192-195 | Volume-8 Issue-12S October 2019 | Retrieval Number: L105610812S19/2019©BEIESP | DOI: 10.35940/ijitee.L1056.10812S19

Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open-access article under the CC-BY-NC-ND license (

Abstract: This paper introduces the Design, Modeling and Simulation of a special tool that attaches a screw to attach the screw to a bimetal of MCB (Miniature Circuit Breaker). Problems found in the current process include complex shape and screw size and full connection operation is an intensive manual operation which makes handling difficult for the operator and also the size of the M2 screw and is headless with a cross section. In partnership with the SPM operator works as a tool to increase productivity by reducing operator fat. The system is a testament to automated material handling system, serial transfer, trap detection, attachment, automatic ejecting system, actuator system, sensors and control capabilities etc. Small screw handling and bike prospect are the major challenges in the special development of a purpose screw attachment system. System Modeling & Simulation analysis is done and the results are encouraging.

Keywords: Modelling, MCB, Simulation, Ejecting System, SPM, Fastening Tool.
Scope of the Article: Machine Design