Performance Parameters in FDM 3D Printed Parts
Lovepreet Singh1, Harjot gill2
1Lovepreet Singh*, Dept. of Mechanical Engineering, Chandigarh University, Chandigarh, India.
2Harjot Gill, Dept. of Mechanical Engineering, Chandigarh University, Chandigarh, India.
Manuscript received on October 18, 2019. | Revised Manuscript received on 28 October, 2019. | Manuscript published on November 10, 2019. | PP: 367-370 | Volume-9 Issue-1, November 2019. | Retrieval Number: A4130119119/2019©BEIESP | DOI: 10.35940/ijitee.A4130.119119
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Rapid changes and evolutionary market has demanded the new ways of production such as adaptive manufacturing techniques. In this research work different response characteristics such as ultimate tensile strength, surface roughness and energy consumed have been investigated from the work piece fabricated using of three dimensional printing. Taguchi based L27 orthogonal array was used to carry out the investigation study using Minitab software. From experimental investigation it has been depicted that layer resolution is the most significant parameter.
Keywords: Production Such As Adaptive Manufacturing Techniques. In this Research work Different
Scope of the Article: Production