Screens for Protection Against Electromagnetic Radiation
Nikolay Legkiy

Nikolay Legkiy, (Corresponding Author) MIREA, Russian Technological University, Vernadskogo, Moscow, Russia, 

Manuscript received on December 18, 2019. | Revised Manuscript received on December 29, 2019. | Manuscript published on January 10, 2020. | PP: 2398-2402 | Volume-9 Issue-3, January 2020. | Retrieval Number: C9048019320/2020©BEIESP | DOI: 10.35940/ijitee.C9048.019320
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)

Abstract: This paper presents the ways to protect workers against the electromagnetic fields in the radio frequency range up to one centimeter using a shielding method. The study focuses on the protective shields for absorbing that are produced from pure sheet metal using carbon filler between the metal sheets. There are compared their characteristics at the frequency range up to one centimeter that were obtained by calculations, modeling and experimental methods. Here are provided calculation formulas, results from computer modeling, experimental results from the metal shield itself and the shield with the carbon black filler. The results are presented in graphs. Comparison analysis of the absorption characteristics was done using a method that measured a signal that was reflected from the shield.. 
Keywords: Work Safety, Electromagnetic Waves, X Band, Shielding, Modeling, Experiment..
Scope of the Article: Network Modelling and Simulation