Machinability Optimization of Abrasive Water Jet Cutting Process on AA6082 Aluminium Alloy
C. Joel1, T.Jeyapoovan2

1C.Joel, Assistant Professor, Department of Mechanical Engineering, Easwari Engineering College, Ramapuram, Chennai, India.
2Dr.T.Jeyapoovan, Professor, Department of Mechanical Engineering, Hindustan Institute of Technology and Science, Chennai, India.

Manuscript received on 02 July 2019 | Revised Manuscript received on 09 July 2019 | Manuscript published on 30 August 2019 | PP: 2134-2140 | Volume-8 Issue-10, August 2019 | Retrieval Number: J93600881019/2019©BEIESP | DOI: 10.35940/ijitee.J9360.0881019
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)

Abstract: Aluminium alloys are extensively used nowadays in various manufacturing industries due to its special properties and high strength. In this study, AA6082 aluminium alloy is taken into consideration by studying the machinability properties using the abrasive water jet cutting process. RSM technique is used for conducting the experiments by varying the input factors such as stand-off distance, abrasive feed and nozzle transverse speed. The effect of hardness and surface roughness is investigated. The correlation between the input parameters and the corresponding output was tested by analysis of variance to check the 95% confidence level.
Keywords: Aluminium alloy 6082, Abrasive Water Jet Cutting, Hardness, Roughness, RSM
Scope of the Article: Design Optimization